[vlc-devel] 1.0.0-rc2 Compile for Slackware64

[Kaloyan Kovachev]

On Mon, 1 Jun 2009 16:25:39 +0200, Jean-Baptiste Kempf wrote
> On Wed, May 27, 2009 at 02:03:07PM +0300, Kaloyan Kovachev wrote :
> >  i am trying to compile 1.0.0-rc2 on a freshly installed Slackware64. So far
> > contribs are compiled successfully after making the changes in the patch
> > attached. I am not sure it is the right way to list x86_64 arch, but it let me
> > compile all contribs without errors.
> Applied. Next time, please make a git format patch.

sorry for that - i have just downloaded the tar not from git ... there are few
more very simple changes (adding --enable-pic for X264CONF in two places and
--enable-shared for ffmpeg), which i will send later as git patch

I also had to change live to add -fPIC and ended creating config.linux64 from
config.linux with this flag inside the Makefile - is this acceptable or it
should be in ./Patches

> 
> > P.S. wouldn't it be better to change ARCH=i386 to ARCH=i686 for the 32bit
> > linux builds, as vlc will probably never run on such old hardware, while it
> > may speed-up the things a bit?
> Usually Linux users don't use contrib.

I was lazy to manually download and compile the missing libs, so just did
'make src' for a quickstart, maybe a distro.mak with only the missing libs
will be a good addition

> 
> Best Regards,
> 
> -- 
> Jean-Baptiste Kempf
> http://www.jbkempf.com/
> _______________________________________________
> vlc-devel mailing list
> To unsubscribe or modify your subscription options:
> http://mailman.videolan.org/listinfo/vlc-devel