[multicat-devel] baremetal multicat

[Davor Spasoski]

Hi Jack,

I guess someone has already helped or you have figured out but anyway.
If you are streaming RTP from the source you should omit the -u part. If you want to send it as a udp stream, you should use -U.

Please let me know of your experience with multicat. I have a few problems with it:
- The 10 minute chunks that I'm creating with 32 bit version can't be seamlessly joined. The 64-bit build doesn't have that problem.
- Sometimes multicat is slow to respond to IGMP query and the multicast switch/router disconnects the stream until multicat request it again.
- I have a small packet loss at irregular intervals of approximately 30 seconds when recording on NFS. When recording to local disk, the problem is not there.

Any advice?

It seems that no one is answering on the devel-forum.

BR,
Davor

________________________________

ONE Telecommunications Services Limited Liability Company Skopje

This e-mail (including any attachments) is confidential and may be protected by legal privilege. If you are not the intended recipient, you should not copy it, re-transmit it, use it or disclose its contents, but should return it to the sender immediately and delete your copy from your system. Any unauthorized use or dissemination of this message in whole or in part is strictly prohibited. Please note that e-mails are susceptible to change. ONE Limited Liability Company Skopje shall not be liable for the improper or incomplete transmission of the information contained in this communication nor for any delay in its receipt or damage to your system.