[vlc] Extracted video clip doesn't play over a network

[Chhaya, Harshal]

Hi,

I need to extract about 5 seconds of video from a larger
video file and test it over a network.

I used the 'transcode' wizard GUI and chose the 'partial 
extract' feature to select the clip from a larger H264 
encoded file.

The resulting clip plays correctly as a file but when I try 
to stream it across a network, vlc can't play back the file 
correctly.

It displays a single frame and then doesn't display any more
frames. Until, I hit 'stop' and 'play' again. If I do re-start
the stream, the video plays for a few seconds and then stops
again.

The single frame being displayed is the first frame of the 
original movie and shouldn't even be in the extracted clip.

If the first frame of the shorter file is the same as the
original video, but the subsequent frames are from the
defined 'start time', I can see why the playback has problems.

I have a couple of questions:
1. Is using the transcode wizard the correct way to extract a
video clip from the middle of a larger file? If not, what's
the best way to get a 5 sec or 10 sec video clip from a larger
movie?

If anyone has a 5 sec movie clip in a streamable format
at less than 2 Mbps bit rate, please send it to me.

2. The transmitter loops the video clip numerous times.
Is there a way force vlc to stop and re-start after each loop
the of the stream?

Thanks,
- Harshal

-- 
This is the vlc mailing-list, see http://www.videolan.org/vlc/
To unsubscribe, please read http://www.videolan.org/support/lists.html